APC Automatic Disconnect Switch Guia do Utilizador descarregar pdf (Página 171)

USER’S GUIDE

AUTOMATIC TRANSFER SWITCH

168

Use FTP or SCP to upgrade one

Automatic Transfer Switch

Instructions for using FTP. For you to be able to use FTP to upgrade a

single Automatic Transfer Switch over the network:

• The Automatic Transfer Switch must be connected to the network.

• The FTP server must be enabled at the Automatic Transfer Switch.

• The Automatic Transfer Switch must have its TCP/IP settings (System

IP, Subnet Mask, and Default Gateway addresses) configured.

To use FTP to upgrade the Automatic Transfer Switch:

1. Open an MS-DOS command prompt window on a computer that is

connected to the network. Go to the directory that contains the

firmware upgrade files, and list the files. For the directory C:\apc, the

commands would be those shown in bold:

C:\>cd\apc

C:\apc>dir

Files listed for a Automatic Transfer Switch, for example, might be the

following:

– apc_hw02_aos_264.bin

– apc_hw02_ats_261.bin

2. Open an FTP client session:

C:\apc>ftp

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 191 192

Sem comentários

APC Automatic Disconnect Switch Guia do Utilizador Página 171