APC AP9630 Guia do Utilizador descarregar pdf (Página 20)

18 UPS Network Management Card 2 User’s Guide

Example 1: To open the output, type:

uio -rc 2 open

Example 2: To view the status of the devices connected to a Dry Contact I/O Accessory that is installed in universal

input/ output port 2, type:

uio -st 2

ups

Some ups options are dependant on the UPS model. Not all configurations may support all options

of the ups command.

Access: Super User, Administrator, Device User

Description: Control the UPS and view status information. See the User’s Guide for information on how

these options relate to that screen.

-disc

<UIO port #> |

<UIO port #>,

<UIO port #> |

Identify new input contact or output relay connections.

Option Arguments Description

-c

off | graceoff | on |

reboot | gracereboot |

sleep | gracesleep

Configure UPS actions.

-r start | stop

Initiate or end a runtime calibration. A calibration recalculates remaining

runtime and requires the following:

• Because a calibration temporarily depletes the UPS batteries, you can

perform a calibration only if battery capacity is at 100%.

• The load must be at least 15% to guarantee that a calibration will be

accepted.

-s start Initiate a UPS self-test.

-b enter | exit

Control the use of bypass mode. This command is model-specific and

may not apply to your UPS.

Option Argument Description

1 2 ... 15 16 17 18 19 20 21 22 23 24

Sem comentários

APC AP9630 Guia do Utilizador Página 20