APC PDRPPNX10-M Especificações descarregar pdf (Página 23)

Installation Procedures: Connect AC Power and Control Wiring

InfraStruXure System - Installation and Start-Up 19

Connect control wiring.

1. Connect the EPO control wires from the PDU and the XR Battery Enclosure (if applicable) to the

EPO board on the UPS. The control wires are harnessed and coiled in the floor of the PDU and the

XR Battery Enclosure. The PDU harness connects to J6 and the XR Battery Enclosure harness

connects to J8.

2. Connect the Maintenance Bypass control wire harness from the PDU to the Maintenance Bypass

interface board of the UPS. There are two wire harnesses coiled and secured in the PDU. One is a 6-

wire harness and the other is a 4-wire harness.

Note: A jumper wire must be installed in position 13 and 14.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Sem comentários

APC PDRPPNX10-M Especificações Página 23