APC NBRK0550 Guia de Instalação descarregar pdf (Página 16)

NetBotz Wireless Temperature Sensor Installation Guide

Cable tie installation

The Wireless Temperature Sensor ships with a pair of adhesive cable tie holders

and tie wraps used to mount it on a perforated rack door.

To mount the Wireless Temperature Sensor on a rack door:

1. Place the sensor in the desired location on the rack door.

2. Place the cable tie holders in the desired location on the rack door. Press

until each tie holder is firmly seated.

3. Insert a tie wrap through the mesh grating and into the mounting slots on

one side of the sensor.

4. Gently tighten the tie wrap.

5. Repeat steps 3 and 4 on the other side of the sensor, if desired.

Wall bracket installation

The Wireless Temperature Sensor ships with a wall bracket, and screws or foam

adhesive strips, used to mount it outside the rack using the magnets on its base.

Note: To maintain access to the QR code, and to make battery

replacement easier, using the foam adhesive strips directly on the

Wireless Temperature Sensor is not recommended.

Replacing the Battery

The Wireless Temperature Sensor uses a 3V CR2477 battery. Battery life is

estimated at up to 5 years under normal use.

To replace the battery:

1. Turn the Wireless Temperature Sensor off.

2. Insert a thin flat screwdriver into a pry slot on the side of the sensor.

3. Gently twist to open the case.

4. Carefully remove the board, and slide the spent battery out.

5. Insert the new battery with the + sign facing the bottom of the battery

holder.

6. Place the board in the cover.

7. Align the arrows on the base and the cover, and press together to close.

8. Turn the sensor on using the rocker switch on its side, and wait for it to

join the network.

Cleaning the Wireless Temperature Sensor

To clean the device, gently wipe surfaces with a clean, dry cloth.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

APC NBRK0550 Guia de Instalação Página 16