APC NBWL0456 Guia de Instalação descarregar pdf (Página 15)

NetBotz Wireless Sensor Pod 180 Installation Guide

Powering a Router

A Wireless Sensor Pod must be connected to an AC-USB power source to

become a Router. Once its extended address is added to the commission list in

the Advanced View, and power is applied, the pod is automatically configured

as a Router.

Warning: Do not use a NetBotz appliance as the USB power

source for a Router device.

To configure a Wireless Sensor Pod as a Router:

1. Mount the pod using the instructions in “Mounting the Wireless Sensor

Pod” on page 7.

2. Ensure the extended address of the pod is added to the commission list in

the Advanced View.

3. Plug the pod into the included AC-USB power source.

Internal sensor listing

When a Router is selected in the Navigation Pane in Advanced View, the

following internal sensors are listed in the Sensor Pane (along with any attached

external sensors):

Sensor Description

Temperature The internal temperature sensor reading.

Humidity The internal humidity sensor reading.

Dew Point The calculated dew point.

RSSI The Received Signal Strength Indicator. This indicates the

strength of the signal the Router receives from its parent

(either another Router or the Coordinator).

A reading above 30% RSSI is ideal.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Sem comentários

APC NBWL0456 Guia de Instalação Página 15