Apc UPS control system Manual do Utilizador descarregar pdf (Página 180)

MAXLINEV is the maximum line voltage since the last STATUS as

returned by the UPS.

MINLINEV is the minimum line voltage since the last STATUS as re-

turned by the UPS.

OUTPUTV is the voltage the UPS is supplying to your equipment.

SENSE is the sensitivity level of the UPS to line voltage ﬂuctuations.

DWAKE is the amount of time the UPS will wait after a power oﬀ con-

dition when the power is restored.

DSHUTD is the grace delay that the UPS gives after receiving a power

down command from apcupsd before it powers oﬀ your equipment.

DLOWBATT is the remaining runtime below which the UPS sends the

low battery signal. At this point apcupsd will force an immediate

emergency shutdown.

LOTRANS is the line voltage below which the UPS will switch to bat-

teries.

HITRANS is the line voltage above which the UPS will switch to batter-

ies.

RETPCT is the percentage charge that the batteries must have after a

power oﬀ condition before the UPS will restore power to your equip-

ment.

STATFLAG is a status ﬂag indicating the UPS status. See STATUS.

ITEMP is the internal UPS temperature as supplied by the UPS.

ALARMDEL is the delay period for the UPS alarm.

BATTV is the battery voltage as supplied by the UPS.

LINEFREQ is the line frequency in Hertz as given by the UPS.

LASTXFER is the reason for the last transfer to batteries.

NUMXFERS the number of transfers to batteries since apcupsd startup.

XONBATT time and date of last transfer to batteries, or N/A.

TONBATT time in seconds currently on batteries, or 0.

CUMONBATT total (cumulative) time on batteries in seconds since

apcupsd startup.

179

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 232 233

Sem comentários

Apc UPS control system Manual do Utilizador Página 180