APC Monitor 78-10169-02 Guia de Resolução de Problemas descarregar pdf (Página 23)

2-23

Cisco ICS 7750 Administration and Troubleshooting Guide

78-10169-02 Rev. B0

Chapter 2 Monitoring the System

Monitoring a UPS

Step 6 Install the UPS:

installups

Step 7 Start FmmServer:

net start FmmServer

Step 8 Go to “Verifying That the Cisco ICS 7750 Can Communicate with the UPS” on

page 2-26.

Configuring the System to Monitor a UPS Through an Ethernet

Connection

If the UPS is connected to an Ethernet switch that is connected to the SSP card on

the Cisco ICS 7750, complete the following steps to configure the UPS so that the

Cisco ICS 7750 can monitor UPS status:

Step 1 Ensure that you have the following information available:

• The IP address that you intend to use for the UPS.

• The IP address of the SPE running System Manager. (If you do not know this

IP address, see “Determining the IP Address of an SPE” in Chapter 1,

“Operating the System.”)

• The subnet mask that you used when you configured the Cisco ICS 7750.

Step 2 Insert the Web/SNMP Management CD-ROM that came with your APC

Smart-UPS into your PC CD-ROM drive.

Step 3 Follow the on-screen prompts to install the SNMP/Web Management Utility.

Note If the SNMP/Web Card Management Wizard does not automatically

run after the software installation is complete, click

Start > Programs > APC Card Management Wizard.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Sem comentários

APC Monitor 78-10169-02 Guia de Resolução de Problemas Página 23