APC RAID Subsystem SCSI-SATA II Especificações descarregar pdf (Página 54)

Chapter 4: Subsystem Connection and Operation

NOTE:

•

The subsystem is shipped with one (1) SCSI-to-SCSI daisy chain

cable (IFT-9270UJBODCAB). If you are going to cascade your

subsystems, extra cables must be purchased separately.

•

To create dual redundant data paths on the host side, it is necessary

to install third-party failover software on the host computer.

4.4 Power On

Once all of the components have been installed in the FALCON II and the

host channels have been connected to the host, the subsystem can be

powered on.

4.4.1 Check List

BEFORE powering on the FALCON II, please check the following:

‰

Memory module: Memory modules have been correctly installed

on the controller boards.

‰

BBU: If used, the BBU has been installed correctly.

‰

Hard drives: Hard drives have been correctly installed in the drive

trays.

‰

Drive trays: ALL the drive trays, whether or not they have a hard

drive, have been installed into the subsystem.

‰

Cable connections: The host ports on the subsystem have been

correctly connected to a host computer.

‰

Power cables: The power cables have been connected to the PSU

modules on the subsystem and plugged into the main power source.

‰

Ambient temperature: All the subsystem components have been

acclimated to the surrounding temperature.

4.4.2 Power On Procedure

When powering on the FALCON II, please follow these steps:

1. Power on the subsystems that are not connected directly to the host

computer, if applied.

If you have daisy chained any FALCON II, power on those

subsystems before powering on the first subsystem that is connected to

your host computer(s).

Power On

4-5

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 93 94

Comentários a estes Manuais

Sem comentários

APC RAID Subsystem SCSI-SATA II Especificações Página 54

Comentários a estes Manuais

Manuais e produtos relacionados com Redes APC RAID Subsystem SCSI-SATA II