APC ACRD500 Manual de Instalação descarregar pdf (Página 26)

InRow RD Operation and Maintenance18

Start the cooling unit

Path: Main > On/Standby

To start the cooling unit, change the setting to On by pressing the ENTER key to toggle from Standby to

On. At that point, the fans will start.

The cooling unit will run according to the configured settings.

Note: On/Standby only affects the local cooling unit. You must set the On/Standby option

for each cooling unit in the cooling group.

Note: To toggle between On and Standby from the scrolling status screens, press the

ENTER

key three times in rapid succession.

Stop the cooling unit

Path: Main > On/Standby

Press the ENTER key to change the setting to Standby. The cooling unit will enter the standby mode.

Electrical Hazard: The Standby option does not remove power from the cooling unit. You

must disconnect power at the mains to remove power from the cooling unit.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Sem comentários

APC ACRD500 Manual de Instalação Página 26