APC AR1100 Manual do Operador descarregar pdf (Página 106)

OPERATING PROCEDURES: Parameter Settings

4 Press the right button or left button to

select the position where a character is entered

or changed

The cursor indicates the position where a char-

acter is entered or changed.

Up to 24 characters can e entered in two lines.

5 Enter comments with the following buttons.

After moving the cursor of the character list to the desired character, press the OK button

to confirm its entry.

The following buttons are available:

6 Repeat Steps 4 to 5 to enter the desired comments.

7 After entering comments, press the exit button to exit from the comment setting

mode.

8 Press the exit button to return to the measurement screen.

The entered comments are saved.

Moves the current selection to the left in the character table.

Moves the current selection to the right in the character table.

Determines the character to be entered and moves the highlight to the next

digit.

Erases the character at the cursor position and moves the highlight to the

previous digit.

It is also possible to erase characters by entering a space (SP).

Test prints the comment only.

• When the start button is held down with the SET COMMENT screen displayed, comments

return to the default setting (“NIDEK TONOREF II”).

㧼㧭㧾㧭㧹㧱㨀㧱㧾ޓޓ㧿㧱㨀㨀㧵㧺㧳

ޓޓ㨇㧿㧱㨀ޓ㧯㧻㧹㧹㧱㧺㨀㨉

ޓ㧍̍㧏㧐㧑㧒̉ޓ 㧖㧗㧙㧚㧜㧝㧞㧟㧠㧡㧢㧣

㧤㧥㧦㧧㧨㧩㧪㧫㧬㧭㧮㧯㧰㧱㧲㧳㧴㧵㧶㧷㧸㧹㧺㧻

㧼㧽㧾㧿㨀㨁㨂㨃㨄㨅㨆㨇㩯㨉㨊㨋

㧯㧻㧹㧹㧱㧺㨀㧦

ޓޓޓޓ㧺㧵㧰㧱㧷ޓ㨀㧻㧺㧻㧾㧱㧲ޓ㧵㧵

Move the cursor to the desired position.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 143 144

Sem comentários

APC AR1100 Manual do Operador Página 106