APC AR1100 Manual do Operador descarregar pdf (Página 22)

BEFORE USE: Device Description

{ Bottom view

Power inlet

Used to connect the detachable power cord.

RS-232C connector

Connect an interface cable to send/receive the measured data to/from a diagnostic device or such.

Target device

RT-2100 series, RT-5100

LM-970, LM-990/990A, LM-1000/1000P, LM-1200

Connecting the lensmeter to the side and the RT-2100/RT-5100 to the side allows data transmission to

the connected refractor via the TONOREF II.

USB-A connector

Connect a USB flash memory when the software needs to be upgraded.

Do not connect any USB device other than flash memory.

The upgrade is performed by NIDEK service personnel.

*1 Accessory equipment connected to the analog and digital interfaces must be certified according to the representative

appropriate national standards (for example, UL 1950 for Data Processing Equipment, UL 60601-1 for Medical Equip-

ment, and CSA C22.2 No. 601-1, EN 60601-1, and IEC 60601-1.) Furthermore, all configurations shall comply with the

system standard IEC 60601-1-1. Anyone who connects additional equipment to the signal input part or signal output

part configures a medical system, and is therefore responsible that the system complies with the requirements of the

system standard IEC 60601-1-1. If in doubt, consult the technical service department or your local representative.

USB-A connector

Power inlet

RS-232C connector

(OUT)

To export the measured data to the refractor (RT), an external computer or such,

connect an interface cable to this side.

(IN)

To import the measured data to from a NIDEK lensmeter, connect an interface cable

to a lensmeter.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 143 144

Sem comentários

APC AR1100 Manual do Operador Página 22