APC AR1100 Manual do Operador descarregar pdf (Página 5)

III

CAUTION

• Do not use a power cord other than the one supplied. Also do not connect the

supplied power cord to any other device.

Failure or fire may result.

• Do not place heavy objects on the power cord.

The damaged power cord may cause fire or electric shock.

• Before connecting cables to the device, turn the device off and disconnect the power

cord from an outlet.

Malfunction may result.

• Before carrying the device, put the device into the packing mode and lock the main

body to the base with the locking lever.

An accidental movement of the measuring unit during transportation may result in mal-

function.

• When the device is carried, two persons

should hold (A) and (B) (both right and left

sides). Avoid holding the forehead rest

and the main body; hold the bottom of the

base.

If only one person carries the device, or

areas other than the base are held and

the device falls, there is a fear of injury or

malfunction.

• In installation and operation of the device, observe the following instructions about

EMC (electromagnetic compatibility):

- Do not use the device simultaneously with other electronic equipment to avoid electro-

magnetic interference with the operation of the device.

- Do not use the device near, on, or under other electronic equipment to avoid electro-

magnetic interference with the operation of the device.

- Do not use the device in the same room with other equipment such as life-support

equipment, other equipment that has major affects on the life of the patient and

results of treatment, or other measurement or treatment equipment that involves

small electric current.

- Do not use the device simultaneously with portable and mobile radio frequency com-

munication systems because it may have an adverse effect on operation of the

device.

- Do not use cables and accessories that are not specified for the device because that

may increase the emission of electromagnetic waves from the device or the system

and decrease the immunity of the device to electromagnetic disturbance.

• The Electromagnetic Compatibility Directive sets the essential requirements for

electrical and electronic equipment that may disturb, or be disturbed by, other

equipment. The TONOREF II complies with these requirements as tabled on pages 121

to 124. Follow the guidance in the tables for use of the device in an electromagnetic

environment.

(A)

(B)

1 2 3 4 5 6 7 8 9 10 ... 143 144

Comentários a estes Manuais

Sem comentários

APC AR1100 Manual do Operador Página 5

Comentários a estes Manuais