APC IP DSLAM Guia do Utilizador descarregar pdf (Página 445)

100

101

437

database is SRD( Shared Routing Database)

where there is a single RID in the system and all

flows map to this RID. This RID has to be explicitly

created and no more than one RID can be created

in the system in this mode. Flows for all created

VLANs shall map to this RID for routing.

Destination

Destination IP address of this route.

Net Mask

Indicates the mask to be logical-ANDed with the

destination address before being compared to the

value in the ipRouteDest field. Only absolute

routes can be added in the downstream direction

for the IPOE interfaces (gsvIpRouteIfIndex as

ipoe-*). The mask for all such routes has to be

255.255.255.255. The creation of default route in

upstreamcan has the mask as 0.0.0.0 only.

Gateway

The IP address of the next hop of this route. Only

absolute routes can be added in the downstream

direction for the IPOE interfaces

(gsvIpRouteIfIndex as ipoe-*). The next hop in

such cases has to be same as the destination IP

address (gsvIpRouteDest) specified.

Ifname

The index value which uniquely identifies the local

interface through which the next hop of this route

should be reached. If IpRouteRid is not

GS_CFG_MGMT_RID, than u32IpRouteIfIndex

shall be mandatory to be specified in the "create ip

route" command. The ifname value can be either

ANYWAN or ifindex of any of the ipoe interface

(ipoe-*).

Route Type

The type of route. It may be: dir (for Direct) or ind

(for Indirect).

Route Orig

The routing mechanism, through which this route

was learned. It may be: NET (for Network

Management), LCL (for Local), RIP, ICMP,DYI

(Dynamic through Interface creation).

Age

The number of seconds since this route was last

updated or otherwise determined to be correct.

ProxyArpStatus

This specifies if the Proxy ARP has to be done for

this iproute table entry.If IpRouteRid value is 0,

then ProxyArpStatus will not be specified while

creating/modifying an entry in IpRoute Table.

References

• get ip route command

• delete ip route command

• arp related commands.

8.16.3 Ipoa intf Commands

8.16.3.1 Get ipoa intf

Description: Use this command to get.

Command Syntax: get ipoa intf [ifname <interface-name>]

8.16.3.2 Create ipoa intf

Description: Use this command to create.

Command Syntax: create ipoa intf ifname <interface-name> lowif

<lowif-val> [configstatus Normal | Config] [enable|disable]

8.16.3.3 Delete ipoa intf

Description: Use this command to delete.

Command Syntax: delete ipoa intf ifname <interface-name>

1 2 ... 440 441 442 443 444 445 446 447 448 449 450 ... 602 603

Comentários a estes Manuais

Sem comentários

APC IP DSLAM Guia do Utilizador Página 445

Comentários a estes Manuais

Manuais e produtos relacionados com Redes APC IP DSLAM