APC IP DSLAM Guia do Utilizador descarregar pdf (Página 574)

100

101

566

Type: Create -- Optional

Modify -- Optional

Default value: 0

bridgingmode Restricted |

Unrestricted | Residential |

CrossConnect

This specifies the state of full bridging for the

VLAN. There can be three values associated

with this, based on global fullBridgingStatus.

These values can be restricted bridging,

unrestricted full bridging and residential

bridging. If the user does not specify the

bridging mode at the time of VLAN creation,

the VLAN inherits the globally set bridging

mode. The user can modify bridging mode for

a created VLAN. If the dynamic entry for the

VLAN to be created already exists, the user

can only specify globally set bridging mode for

this VLAN. The bridging modes are defined as

Restricted Full Bridging, Unrestricted full

bridging and Resedential bridging. The default

residential VLAN, like any other residential

VLAN allows only one net side bridge port as

its member. This port shall be added

automatically to the default VLAN if it is the

only net side bridge port being added to the

VLAN. Subsequently, the user can add

another net side port to the egressportslist

and untaggedportslist only after removing the

previously added net side bridge port.

Unrestricted bridging is not applicable for

bridge ports created over the PPPoE interface

even though the VLAN may be unrestricted.

Type: Create -- Optional

Modify -- Optional

Valid values: usly added net side bridge port.

Unrestricted bridging is not applicable for

bridge ports created over the PPPoE interface

even though the VLAN may be unrestricted.

Default value: Resedential bridging

floodsupport enable |

disable

This specifies if the flooding has to be done

for unknown unicast packets for this vlan or

not.The default value for this shall be taken

from enable when vlan is created. The

unknown unicast packets shall be flooded on

all ports for a vlan if global value (present

inDot1dTpInfo) is enabled or throttle, and the

value pervlan is also enabled else dropped.

Type: Create -- Optional

Modify -- Optional

Default value: enable

bcastsupport enable |

disable

This specifies if the broadcast has to be done

for this vlan or not. The default value for this

shall be taken from enable when vlan is

created. The broadcast packets shall be

flooded on all ports for a vlan if global value

(present in Dot1dTpInfo) and the value per

vlan are both enabled else dropped.

Type: Create -- Optional

Modify -- Optional

Default value:enable

resvmacprofileid

<resvmacprofileid-val>

The Profile associated with this Vlan to be

used to determine the behavior for Reserved

Mac destined frames. Reserved Mac

1 2 ... 569 570 571 572 573 574 575 576 577 578 579 ... 602 603

Comentários a estes Manuais

Sem comentários

APC IP DSLAM Guia do Utilizador Página 574

Comentários a estes Manuais

Manuais e produtos relacionados com Redes APC IP DSLAM